===========================Spec in Config File==============================
  1.Entone Basic Information
      STB Info: num=27, enum=14, model=301-100 (C1-100)
      Hardware Model = 27 (Amulet500)
  2.Remote Information
      Has RF remote = 1
      Has IR remote = 1
  3.Standby Mcu Information
        This model (27) do not have MCU
  4.Clock Display Information
      Has Clock Display = 1
      Colon gpio (Active Low) = 0/0 (0)
  5.Touch Panel Information
      Has Touch Panel = 1
        Has Led = 0
        Interrupt Pin gpio/type (Active Low) = 111/0 (1)
        i2c Address(HEX) / Port = 0x16 / 1
        Key Format = 1 (default is 0)
        i2c clock frequency = 50 kHz
  6.Indication LED (LINK/HD/REC) Information
      Has Indication LED = 1
        This model (27) use Segment mcu to control Led.
        !!!!!!But there are no Standby MCU.
        i2c Address(HEX) / Port = 0xe0 / 1
        i2c clock frequency = 50 kHz
  7.Power LED (RED/BLUE) Information
      Has Power LED = 1
        RED led gpio/type (Active Low) = 0/5 (0)
        BLUE led gpio/type (Active Low) = 1/5 (0)
        POWER_LED_ONOFF gpio/type (Active Low) = -1/0 (0)
  8.Power Button Information
      Has Power Button = 1
        Power Button gpio/type (Active Low) = 10/4(AonStandard) (0)
        Power Button has SW reboot feature (timeout=5)
        Power Button has HW reboot feature
        Power Button will read value first
  9.Reset Hole Information
        This model (27) does not have Reset Hole.
  10. WPS Button Information
        Has WPS Button = 0
        This model (27) do not has WPS button.
  11.Fan Information
      Has Fan = 1
        Fan Control Type = 1 (FAN_PWM_TYPE)
          Fan Pwm Channel  = 0 
          Fan Control Word = 22 
          Fan Freq         = 255 
          Fan Duty-off     = 256 
          Fan Duty-low     = 58 
          Fan Duty-middle  = 98 
          Fan Duty-high    = 255 
          Fan Duty-kickoff = 98 
  12.RF Output Select Pin Information
        This model (27) does not have RF Output Channel Select Pin.
  13.External Antenna Power Information
        This model (27) does not have External Antenna Power.
  14.Standby Information
      Standby Enabled
      Wake-on-GPIO Enabled
  15.Number to AON input GPIO to control: 1
      PIN: 10: POWER_BUTTON
============================================================================